Motorcycle chain maintenance
A well-kept chain makes gear changes smoother, saves fuel and lasts far longer. It only takes a few minutes every couple of weeks.
How often to clean and lube
A common rule of thumb is every 500–700 km, and always after riding in rain or washing the bike. If the chain looks dry, rusty or gritty, it's due.
Cleaning the chain
- Put the bike on a centre or paddock stand so the rear wheel turns freely.
- Spray a chain cleaner on the chain and use a soft chain brush to lift the grime. Avoid petrol, harsh solvents and wire brushes: most modern bikes use O-ring or X-ring chains, and those can damage the seals.
- Wipe the chain dry with a clean cloth.
Lubing the chain
- Lube works best on a slightly warm chain, so do it after a short ride.
- Spray chain lube on the inner side of the chain (where it meets the sprockets) while turning the wheel slowly by hand. Never turn the wheel with the engine running.
- Let it set for the time on the can (often 10–15 minutes) and wipe off the excess so it doesn't fling onto the tyre.
Check the slack
Push the chain up and down midway between the sprockets. The free play your bike needs is in the owner's manual (it's often around 20–30 mm, but it varies by model). A chain that's too tight wears the gearbox output shaft and wheel bearings; too loose and it can slap or jump the sprocket. Adjust both sides evenly so the wheel stays aligned.
When to replace
- The chain keeps going slack soon after adjustment, or the adjusters have run out of room.
- You can pull the chain away from the back of the rear sprocket and see daylight.
- Sprocket teeth look hooked or pointed instead of evenly rounded.
- Tight spots or stiff links that don't free up after cleaning.
Always replace the chain and both sprockets together. A new chain on worn sprockets (or the other way round) wears out quickly.
Find chain & sprocket kits listed by bike model, and chain cleaners and lubes in oils, lubes & maintenance. Our Madurai workshop can also service or replace your chain kit.